![background image](http://html1.mh-extra.com/html/tando/rtr-500dc/rtr-500dc_introductory-manual_3473616011.webp)
11
Introduction
Wireless Regulations
Radio, EMC and Safety Regulations
This device complies with part 15 of the Federal Communications Commission
(FCC) rules and with RSS-210 of the Industry Canada (IC). Operation is
subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Changes or Modifications not expressly approved by the manufacturer for compliance could
void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to Special Short Range
Wireless Communication.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment must be installed and operated with a minimum distance of
30cm between the radiator and your body.
This device has been designed to operate with the supplied antenna only. Use of any other
antenna is strictly prohibited. The supplied antenna has a maximum gain of 0dBi, and has an
impedance of 50 ohms.
Important Notice
We cannot sell these products to distributors or consumers in countries other than where the
wireless Units have been approved for use. If these wireless products are used outside of
the designated areas of the Americas where the devices have been granted approval, T&D
Corporation shall in no manner whatsoever take responsibility for the usage of these products,
nor be liable in any manner for legal consequences stemming from the usage of these
wireless products in unapproved areas.