FRONT CONNECTIONS
RED DOT
INSULATION SLEEVES
010410-16 TC54.NG02.C
3. Attach the pilot supply tube from the lower burner pilot to the
front bulk head fitting and tighten. (Fig. # 3) Ensure there are no
leaks.
4. Transfer insulation sleeves from front electrical bulkhead
connections to the pilot wires leading from the lower burner
pilot. Attach spark electrode (RED) and sensor leads from lower
burner pilot to the front electrical bulk head. ( Fig. # 3) (The spark
electrode connection has a red dot above it) Slide the insulation
sleeve back onto the bulkhead connections. (Fig #4) Replace
the ceramic fibre filler piece into the lower burner assembly.
A panel set must now be installed. See Installation and
Operating Instructions manual for details.
5. Position the grate and attach it to the floor with two screws located
behind the front legs. (Fig. # 5)
6. Attach the manifold supply tube from the upper burner to the
rear bulk head fitting and tighten. (Fig. # 6) Ensure that there are
no leaks.
RED END
Fig. #3
Fig. #4
Fig. #5
Fig. #6
3
