010410-16 TC54.NG02.C
Before adding the ember material please ensure that the ceramic fibre filler pieces are cor-
rectly located in the bunrer as per figure #28.
Two bags of ember material is shipped with the fireplace and need to be installed to ensure
optimum performance and flame appearance.
Pull apart the material into ember size pieces (approximately 1” squares) and gently place
them into the lower burner pan. Do not compress, leave it loose for best performance. Fill
the lower burner pan level with the top of the pan at rear, and gradually slope forward to the
firebox floor, covering both lower burner tubes. Place remaining ember material outside of
the burner pan as desired to cover-up gas lines and brackets.
Note: Ember material placement and amount will affect flame appearance. More ember
material results in lower flame height. Add or remove as needed until desired flame affect.
Do not place any ember material on the upper burner tube.
Ember Material Placement
GLOWING EMBERS
LOG GRATE
Fig. #28a
Fig. #28
CERAMIC FIBRE
FILLER PIECES
10
Ember Material
