T&C TC30, Instructions For Intallation

Page: 5 / 16

A large bag of ember material is shipped
with the fireplace and needs to be installed
to ensure optimum performance and flame
appearance.
1. Pull apart the material into ember size
pieces (approximately 1” squares) and
gently place them into the burner pan.
Do not compress, leave them loose for
best performance.
2. Fill the burner pan with embers until
level with the top of the pan at rear, and
gradually slope forward to the firebox
floor at the front, covering both burner
tubes.
3. Place remaining ember material outside
of the burner pan as desired to cover-up
gas lines and brackets.
Note:
Ember material placement and
amount will affect flame
appearance.
More ember material results in
lower flame height.
Add or remove as needed until
desired flame affect is achieved.
Reduce the amount used on
Propane models, as too much will
create soot.
Fig #7
5
TC30.NG01.C 140708
Ember Material