Installation
TANDBERG Director Videoconferencing System
21
Powering on the System
Once the system is installed in the
appropriate location, it is now ready for the
AC mains to be plugged in. To verify that all
components have been powered on, you
should be able to see the following LED
indicators through the smoked glass cover
of the Director Application Module.
If any of the green or red LED’s do not show
through the smoked glass, the system will
not work properly. Contact TANDBERG
Technical Service immediately.
To power on the projector, press the green
P
ROJECTOR
S
TANDBY
button on the front of
the 3000i cabinet. Once powered, refer to
‘S
YSTEM
S
ETUP
’
for screen calibration.
RED
YELLOW
GREEN
N O T E
I
T
IS
RECOMMENDED
THAT
YOU
PRESS
THE
GREEN
PROJECTOR
STANDBY
BUTTON
TO
PLACE
THE
SYSTEM
IN
STANDBY
WHENEVER
IT
IS
NOT
IN
USE
. T
HIS
WILL
MAXIMIZE
THE
LIFE
OF
LAMP
INSIDE
THE
PROJECTOR
.
System Setup
SMART Board
TM
Projector Setup and Calibration
When you press the
POWER
BUTTON
on the 3000i
front control panel unit to activate the projector
display, it will then require approximately 40
seconds to complete the start-up routine, at
which point the TANDBERG
start-up screen
will
be displayed.
For SMART Board
TM
software installation and
configuration, or any additional information,
please reference the ‘R
EAR
P
ROJECTION
SMART
B
OARD
TM
3000i I
NSTALLATION
G
UIDE
’.
