TANDBERG Border Controller User Guide
Page 75 of 118
To upgrade using SCP or PSCP:
1.
Make sure the system is turned on and available on IP.
2.
Upload the release key file using SCP/PSCP to the
/tmp
folder on the system e.g.
scp release-key [email protected]:/tmp/release-key
or
pscp release-key [email protected]:/tmp/release-key
3.
Enter password when prompted.
4.
Copy the software image using SCP/PSCP. The target name must be
/tmp/tandberg-
image.tar.gz
, e.g.
scp s42100q60.tar.gz [email protected]:/tmp/tandberg-image.tar.gz
or
pscp s42100q60.tar.gz [email protected]:/tmp/tandbergimage.tar.gz
5.
Enter password when prompted.
6.
Wait until the software has installed completely. This should not take more than two minutes.
7.
Reboot the system.
After about four minutes the system will be ready to use.
