Tandberg Data SDLT220-320 INTEGRATION, Product Manual

Page: 63 / 142

CHAPTER 4: Installing Your Tape Drive
Figure 4-4.
SDLT 220/320 — Two Views (Front + Side + Top and Back + Side + Top)
Securing the Internal Tape Drive
This section describes how to mount and secure the drive in the system.
N
OTE
: In some system configurations it may be more convenient
to connect the SCSI bus and power cables to the drive
before securing it in the system.
Because of the variety of mounting possibilities for tape drives, the instructions
presented here are general in nature. They should be used only as a guide for
mounting the drive in your system.
Mount the drive in the system by performing the following steps:
1. Position the drive in the system and align the drive mounting holes (side or
bottom) with those in the system.
Figure 4-5 on page 4-12 shows the
mounting locations and dimensions for the drive.
C
AUTION
: The screws used to mount the tape drive must be #6-32
UNC-2B screws. This type of screw is exactly the proper
length and will not damage the tape drive.