APPENDIX B: DLT IV Tape Cartridge
6.
Ensure that the tape leader within the tape cartridge is in the correct position.
To do this, open the tape cartridge door by holding the DLT cartridge as
shown in
Figure B-3
.
Figure B-3.
DLT Tape Leader Loop in its Correct Position
7.
On the right side corner of the tape cartridge there is a small tab in a cut-out
portion of the cartridge. Using your thumb, gently lift up on the tab and swing
the door open.
8.
Inside the door, you will see the tape and cartridge leader loop. The loop
should stick up about an eighth of an inch when viewed from the edge; the
loop must be a closed loop. If the loop is torn, bent, pulled in, or not sticking
up about an eighth of an inch, do not use the tape cartridge.
Figure B-4
shows three different tape cartridge loop problems. No tape
cartridge that exhibits the type of problems shown in the examples in
Figure B-4
should be used in an SDLT system.
Summary of Contents for SDLT220-320 INTEGRATION
