Tanco E100 SA, Operator'S Handbook Manual, Page: 24 / 88

Tanco Autowrap - E100
Operator’s Manual
23
6. MACHINE SETUP
Table Stop Adjustment (See Fig. 6.14)
The E100 Turntable is fitted with a mechanical locking mechanism that aids finding the correct tipping position
and then prevents the table from turning while tipping. Screw (3) can be adjusted to change the height of the of
the rocker plate (2). The turntable should pass over the rocker plate when turning forward and the latch (1)
should come against the rocker plate when the table is turning in reverse.
Cut & Start Accumulator Recharging (See Fig. 6.15)
The Cut & Start Cylinder is attached with an accumulator ball which may require recharging. In the event
that recharging is required please follow the following steps;
1. Remove the plug from the port (1) on the cylinder.
2. Connect the hose from a hydraulic hand pump (5) to the cylinder port (1).
3. Charge the cylinder to a pressure of 60 Bar (870 P.S.I)
4. Remove the hose from the cylinder port (1) and refit plug.
3
1
2
Fig. 6.14
2
4
5
3
1
60 BAR
870 PSI
Fig. 6.15