English
FD-M
Page 36
Checking the package contents
Check the contents of the package for completeness immediately after
unpacking:
§
one decoder, with or without soldered connecting wires, depending
on the version.
§
one manual.
Required tools and materials
Make sure you have the following tools, equipment and materials ready
for use:
§
an electronic soldering iron (max. 30 Watt) with a fine tip,
§
a soldering iron stand,
§
a tip-cleaning sponge,
§
a heat-resistant mat,
§
a small side cutter and wire stripper,
§
a pair of tweezers,
§
tin solder (0,5 mm. diameter),
§
wire (diameter: > 0,05 mm² for all connections).
§
When the total current consumption is more than 1,0 A: a heat
sink, e.g. a SMD heat sink with a base of 7 x 19 mm.
Safe and correct soldering
Caution:
Incorrect soldering can cause dangers through fires and heat. Avoid
these dangers by reading and following the directions given in the
chapter
Safety instructions
.
§
Use a small soldering iron with max. 30 Watt. Keep the soldering tip
clean so the heat of the soldering iron is applied to the solder point
effectively.
