tams elektronik HELIOS, Manual

Page: 54 / 60

!
English HELIOS
LED displays when starting operation:
Light sequence on
all 4 LEDs HELIOS waits for you pressing the button to start
the shuttle operation.
LED1 flashing Track 1 HELIOS does not detect a
locomotive on the track assigned to
the LED, although the track has been
defined as a starting track.
Possible causes: bad contact or
wrong position of the locomotive.
LED2 flashing Track 2
LED3 flashing Track 3
LED4 flashing Track 4
Switching points
The points at the intermediate stops and the terminus stations are
always set correctly before the locomotives start from a terminus
station or an intermediate stop. When points have been switched
externally, the setting of the points will be adjusted at this moment.
Make sure, that the points are not switched externally after the
locomotives have started. As a consequence, collisions with oncoming
trains possibly occur.
Finishing shuttle operation
When pressing the button in standard operation until the LEDs flash, all
locomotives are driven to their starting tracks and operation will be
stopped. Hint: Depending on the operating status, this can take some
time. By pressing the button again, operation will be restarted.
LED display when finishing operation:
Flashing of all
4 LEDs Operation has been finished by pressing the
button, all locomotives are driven to their starting
tracks. As soon as the locomotives have reached
their starting tracks, the LEDs stop flashing.
Page 54