TallyGenicom 6600 Series, Applications Manual

Page: 37 / 330

7.5 CPI
37
•
Second Graphics Pass - ^M0303040^KH^KFOPTION^KF^KH^-
^KH Toggles Half-Tone Mode ON and defaults to last
pattern selected (EA).
^KF Toggles ON Half-Dot Mode.
OPTION Data printed with the selected pattern (EA) in Half-
Tone/Half-Dot Mode.
^KF Toggles OFF Half-Dot Mode.
^KH Toggles OFF Half-Tone Mode.
Block Character Fonts
Block character fonts are created from the block character set in four graphic
orientations, and are available in the following sizes:
•
7.5 CPI block characters, 0.2 inches high.
•
10 CPI block characters, 0.1 inch high.
•
12 CPI block characters, 0.1 inch high.
•
15 CPI block characters, 0.1 inch high.
7.5 CPI
The 7.5 CPI character set is 2/10 inches high and 0.15 inches wide (0.51 cm
high by 0.38 cm wide). All characters in this set are printed in upper case,
even if the characters received from the host are lower case.
Command ^{M,U,V,E}0000jjD<data>^-
Arguments
^{M,U,V,E} One of four Graphics Pass orientations (^M for
horizontal, ^V for clockwise rotation, ^E for
counterclockwise rotation, or ^U for upside down
and reverse order of characters.)
0000 A height/width value of 0000 specifies 7.5 cpi
characters.
jjd Justification values in increments of 0.1 inches
(0.25 cm) and dot rows as discussed in the
Graphics Pass Command description below. This
field may be omitted entirely if the justification value
is zero.
<data> The characters to be printed.
Example: The Graphics Pass ^M00000007.5 CPI CHARACTERS^- prints: