Tally Dascom DM-310/320 User Guide V1.0
58
4 SETTING/CHECKING MODES
Besides the ordinary print mode, the printer has the following modes to set or to check settings
of the printer.
Self-test Mode
Hexadecimal Dumping Mode
4.1 Print a Parameter Setting Page (Self-test Page)
Before you connect the printer to the computer, make sure that the printer is in proper working
order. You can do this by printing a configuration status label.
Follow the steps below to run this mode.
1.
Make sure the media is properly loaded, the top cover of the printer is closed
and the printer is power off. Then, press and hold the Feed button once you are
ready.
2.
Turn the printer power on, keep the FEED button held for about 1 second, and
then release the FEED button till Power LED blinks once, buzzer beeps once.
3.
The printer then starts self-printing.
The printer then starts printing current status of the printer.
With the LAN interface, before printing starts, it takes 6 seconds if the IP
address is fixed and 13 seconds id the IP address is obtained with the
automatic setting. (It may take longer depending on the response time from
the host.)
Summary of Contents for DM-310
