Talkswitch TS-9112i, Installation Manual

Page: 11 / 29

Model TS-9112i Installation Guide 5
Installation and Setup
Installation and Setup
The TS-9112i sets up as a direct network connection to the Ethernet wall
jack. Power is supplied through the power adapter provided.
Note: All Ethernet cables used must be category 5/5e straight-through cables, such
as the cable provided with your phone.
Connecting to the Network and to Power
Located at the back of the phone is one cable port jack. This port
marked
l
is used to connect the phone directly to the network. Use the
power adapter included with your phone to plug it into a power source.
Warning: Use ONLY the AC power adapter included with your TS-9112i
IP Phone. Non-compliant adapters provide higher voltage output and
may damage your TS-9112i IP Phone.
1. On the back of your phone, connect the Ethernet Cable (provided with
your phone) into the network port
l
.
2. Plug your power adapter into the power jack in the back of the phone.
3. Plug the other end of the Ethernet Cable into the network jack on the
wall.
4. Plug the power adapter into a power outlet.
Ethernet
Cable
Network Jack
(if Inline power provided)
To Network
Other Network Devices
Separate
Network
Jack