30450712 MPEG-4 Hi-Resolution DVR
13
l
Manual recording
n
Press “ REC” button on the remote controller or “?” on the front panel (need input the
administrator password)
n
Check the status of each channel in the recording menu; “
■
” channel are in recording. while “?”
means the channel1 is not in recording
n
Select the channel to be recorded, please press the related number key (or use “
p
q
” key/jog
shuttle choosing) make the channel “
■
” on the screen then press
Enter
to start recording
n
Repeat above steps and make the channel “?” to stop the camera from recording
n
Press ESC to return.
l
Alarm recording
n
Connect the alarm input according to the device connection and the instructions
n
Set the related item in the menu to start alarm recording See details at Menu -> Setting-> Alarm
setting
l
Motion detection recording
n
Record the channel only in need of motion detection first confirm whether this channel is on
schedule recording if it is, please close the schedule recording
n
Set the related items in the menu to start motion detection recording see details at Menu ->
System setting -> Motion detection.
3.3
Alarm connection operation
l
Connect the alarm input according to the device connection and the instructions
l
Connect the related alarm output according to the necessity ( Example : light, beeper, etc..)
l
Set the related item in the menu. See details at Menu -> System setting -> Alarm setting
3.4
Pan-Tilt-Zoom control operation
l
Confirm the right connect of PTZ and the decoder and set the proper decoder address
l
Confirm the right connection of decoder’s A,B line and the 15-pin port’s A,B line of DVR
l
Set the related items in the menu. See details at Menu -> System setting -> Pan-Tilt control
l
Shift the monitor image to the single window monitor of the channel in need of Pan-Tilt control
l
continuously press “ Assistant” on the remote controller or “Fn” on the front panel to shift the items on
the screen
l
Use direction key to move and control the selections on the screen
3.5
Network connection operation
l
Confirm the correct network connection between DVR and computer
l
Set the IP address, subnet mask and gateway of the computer and DVR separately ( if there is no router
among the network, only the IP address, if there is routers in the network, please set the related
gateway and subnet mask)
l
Use ping ***.***.***.*** (IP address of DVR) to check the link of the network, replied TTL values less
the 64 is normal
l
Open IE Browser and input the IP address of the DVR you want to log in
l
Network operation see details at Chapter 5 operation through network.
