TALEX Spółka z ograniczoną odpowiedzialnością
Spółka komandytowa
ul. Dworcowa 9c
77-141 Borzytuchom
tel. (59) 821 13 40
e-mail.
Page
31
of
76
When operating and shutdown the sweeper without dirt tank
While operating and shutdown:
After connecting the sweeper to vehicle and Turing shutdown.
The front supporting wheel must be fitted!!!
Reason:
If the front supporting wheel will not be fitted, the whole machine weight will Rest on roller
brush and cuase its deformity.
8. Maintenance and replacement of parts
8.1 Assembly and disassembly of roller brush
Before replacing, make sure that the sweeper is disconnected from the power supply and the
resulting pressure in the hydraulic system has been released.
8.1.1 Hydraulic engine:
Unscrew the fixing screws of engine cover and next the hydraulic engine with the body.
Attention !!! This operation does not need removing the hydraulic motor from the shaft, instead
unscrew the engine’s hydraulic hoses.
8.1.2 Bearing unit:
Unscrew the cover screws of bearing unit (1) from the body. Bolt securing the longitudinal movement
need to be loosened using the 4 mm Allen key and unscrew the bolts connecting the bearing cover
with the body. Cover with bearing remove from the shaft. Lift the machine
(eg. using a forklift), secure with stable supports. Then remove the retaining ring Z40 (2) and remove
the flange securing (3) longitudinal move of brush’s segments (4) - which allows for the exchange of
individual segments of the roller brush by sliding them out of the shaft (5).
During assembly carry out the same action, but in reverse order. Use new washers under screws and
new retaining ring.
