TALEX Spółka z ograniczoną odpowiedzialnością
Spółka komandytowa
ul. Dworcowa 9c
77-141 Borzytuchom
tel. (59) 821 13 40
e-mail.
Page
24
of
76
6.Preparing for work
Before starting work:
- make a visual assessment of the sweeper’s condition, if you detect any defects promptly remove
them
- attach the sweeper onto the carrier vehicle,
- connect the sweeper’s hydraulic hoses to sockets of one section hydraulic distributor outside the
vehicle,
- lift up sweeper at about 30 cm from the ground to check the accuracy of couplings’ connection, if
the sweeping roller will rotate in the wrong direction or it will not rotate, then switch places of
couplings’ pins,
-set sweeper so that it is based on all three supporting wheels, suspension components marked with
a red arrow in Fig. They have to be in the middle position as shown in the figure, which allows for
independent work of sweeper in relation to the carrier vehicle
7. Proper installation of the sweeper
7.1 Roller brush
DANGER
During the aggregate, do not stand between the machine and the vehicle.
The person who helps to aggregate the machine should be placed outside
the danger zone and be visible all the time for the operator.
