TALEX Spółka z ograniczoną odpowiedzialnością
Spółka komandytowa
ul. Dworcowa 9c
77-141 Borzytuchom
tel. (59) 821 13 40
e-mail.
Page
30
of
59
This hay rake was designed to work with the tractors of more than 30 HP, fitted with the rear
three point linkage of category I or II. Attaching of the machine to the tractor should take
place on the hard and level surface.
In order to link the hay rake to the tractor:
Reverse the tractor to the machine,
Cautiously realign the three point linkage of the tractor with the headstock of the
machine. Bear in mind that no one is allowed to stay near the machine and the tractor
during the tractor manoeuvres, especially to stand in between the tractor and the
machine when the machine is hitched up.
Put the tractor lower linkage arms as close as possible to the lower linkage points of
the machine
Stop the tractor, put all controls in neutral and engage the hand brake. For the safety
reasons it is recommended to stop the engine and remove the ignition key whenever
you leave the operator’s seat in the tractor cab.
Make sure the handbrake is
fully
engaged
. You need to take extra precautions when safe stop is not possible, e.g. when
operating external controls.
Start connecting the implement with the left hand lower link arm, as you can adjust
the right hand lower link arm stay rod easy.
Always make sure after connecting the
implement that the lower link arms are level. Use the linkage pin of category matching
the category of the three point linkage on the tractor.
Secure the lower linkage points from falling out using the linch pins.
Lift the implement slightly, retract the stand into its working position and lock it off
with pin supplied.
Then lower the machine down again.
Release the top link arm from the transport lock and connect it to one of its fixed
position holes on the headstock. Secure the top link using the linkage pin of category
matching the category of the three point linkage on the tractor (see figure 11
above).Secure the linkage pin with a cotter pin.
Note that the slide is only to be used
in work
. Use of the slide in transport can cause serious damage to the machine as a
result of unnecessary stresses transferred to the main pivot pin.
Always use the
correct slot for transport / work.
Caution
Familiarize yourself with the operating manual before attaching the hay rake
to the tractor. Extra care must be exercised when linking the implement to
the tractor.
