TALEX Spółka z ograniczoną odpowiedzialnością
Spółka komandytowa
ul. Dworcowa 9c
77-141 Borzytuchom
tel. (59) 821 13 40
e-mail.
Page
17
of
59
8. Description of the machine
8.1 Technical characteristics - parameters
Table 3
. Technical parameters
NO Description
Unit
420 model
360 model
1
Overall length in transport position
[mm]
4000
3550
2
Overall length in working position
[mm]
3965
3550
3
Overall width in transport position
[mm]
2300
2200
4
Overall width in working position (min.-max.)
[mm]
3910-4510
2800-3400
5
Maximum height in transport position
[mm]
2770
2300
6
Working width
[mm]
4200
3600
7
Tractor horsepower requirement
[HP]
min. 30
Min. 40
8
Maximal PTO rotations
[rpm]
540
9
Recommended PTO rotations
[rpm]
300÷400
10 Unladen mass
[kg]
630
570
11 Number of rotors
[pcs.]
1
12 Number of rotating arms
[pcs.]
11
9
13 Working capacity
[ha/h]
4-4,5
3,4-3,9
14 Working speed
[km/h]
10
15 Noise level
[dB]
<75
16 Number of wheels
[pcs.]
4
17 Tire size
-
15x6.00-6
18 Tire pressure
[bar]
2.2-3.0max.
8.2 Technical characteristics – major components
The construction of the machine is shown in the picture NO 2. The headstock of the machine
(1) is connected to the main frame (2) via the main pivot pin and additionally via a pair of
steering rods with spring compression (4). The rods are mounted one at each side and are
responsible for centralizing of the machine behind the tractor. The machine is fitted with 11-
arm rotor (9). Inside the rotor solid cast housing there is an oil-immersed cam track on which
run cam rollers connected to the individual tine arm housings. This allows for smooth, low-
friction transmission. The tubular tine arms are fitted into the arm housings. The movement
of cam rollers provides simultaneously the pivoting and rotary movement of the tine arms.
In standard option, there are six folding arms (10) and five fixed ones (12), each fitted with a
set of four, angled, double raking tines. The rotor is mounted directly on top of the
undercarriage which is fitted with twin wheeled rocking beam system allowing for efficient
contour following. Additionally, the machine has got a manual winding mechanism (8) to
adjust tine height against the crop. After setting of the desired raking height, the threaded
rod should be locked in place by means of a three-armed counter nut. The hay rake is
equipped with safety barriers on both sides (5 and 6) to limit access to the hazard zones and
a tarpaulin crop deflector (7) mounted on a telescopic bracket being an integral part of the
left safety barrier. The desired width of a windrow can be set by sliding the shield arm in or
out the outer profile. The inner profile should be locked in position with a lynch pin to
prevent it from falling out.
