TALEX Sp. Z O.O. Sp.K.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. (59) 821 13 26.
English mob.: +48 507 828 310
e-mail.
www.talex-sj.pl
User Manual
FastCUT 300 Disc Mower
Page
20
of
56
After the machine has been hitched, lift and secure the parking stand (3), connect the coupling (1)
in Fig. 4 and adjust its length so it forms an angle of 4÷5˚ in relation to the ground. Decreasing the
angle raises the mowing height. Care must be taken to ensure that the original safety devices are in
place. Each time the mower is mounted on the vehicle, check the connecting elements, i.e. pins and
plugs, for wear. In case of wearing out replace them with new ones.
II. Installation of the machine’s drive shaft.
After mounting the machine on the three-point hitch suspension system, mount the jointed
telescopic drive shaft onto the PTO (4) of the tractor and the power input shaft of the machine and
lift the support to the upper position.
For the mower drive, use only original articulated telescopic shaft with the CE marked
friction clutch and cone guards for PTO (take-off) and PTO (take-on) shafts.
Check if the
latches are securely clamped after sliding the articulated telescopic shaft caps onto the
PTO (take-off) and PTO (take-on) shafts cones. For power hydraulics, use suitable and
tight hoses with matching couplings.
III. Installing power hydraulic system
The mower features one hydraulic control system. The mower is equipped with a stub pipe to be
connected to the supply system of the tractor with a connection pipe (5). Make sure the lines are
routed correctly and the hydraulic connections are clean. Before connecting, make sure that the
system is not under pressure. Ensure that the type of oils used in the tractor's and machine's
systems is the same.
To dismount the machine, follow the above instructions in a reverse order, exercise
particular caution when disconnecting the mechanical system between the machine and
the vehicle.
Before uncoupling the mower from the tractor's suspension system, lock
the carrying arm in the parked position.
After uncoupling the machine from a
vehicle, it must be disassembled and stored under shelter on a flat and hard
surface, on its parking support.
