d. To stop the rocking/waving function, press the on/off button below the speed/tilt
angle display. The unit will complete one full rotation then stop in the horizontal
“home” position. The speed indicator light will flash until the rotation is complete.
When the cycle is complete, the unit will automatically move to standby mode
and the standby indicator light will
illuminate.
opErating tipS
When the unit is running at slow speeds or high angles, making large changes to
the tilt angle or speed may take several minutes to complete. The quickest way to
make large changes is to stop the unit, change the speed or tilt angle, then restart by
pressing the on/off button below the speed/tilt angle display.
5. Setting time to zero (0:00) and continuous mode: Accumulated time.
a. Press and hold the on/off button below the time display. After three (3) seconds
the display will indicate the previous set time.
b. Simultaneously press both the up and down arrows, the display will indicate
zero (0:00). The unit time is now set to zero (0:00) minutes. Alternately, you can
use the up/down arrows to get to zero (0:00).
c. Press the on/off button below the time display. The display will indicate the
accumulated time. The up/down arrows will become inactive. To stop timer,
press the on/off button again. iMportant: This will not interrupt the rocking/
waving function. Press the on/off button below the speed/tilt angle display to
interrupt the rocking/waving function.
d. To reset, press and hold the on/off button below the time display. After three (3)
seconds the display will indicate the previous set time, which was zero (0:00).
6. Setting timed mode: Programmed time.
a. Press the up/down arrows below the time display until you reach the desired
time.
b. Start this function by pressing the on/off button below the time display. The unit
will run for the selected time, the up/down arrows will become inactive while the
timer is running. The unit will stop rocking/waving when time display reaches
zero (0:00). Four (4) audible beeps will indicate the count down function is
complete. The time display will default back to the set time. To repeat for the
same time, simply press the on/off button again.
c. To interrupt an automatic timing cycle before it is completed, press the on/off
button below the time display. The time display will flash off and on to indicate
the time function is on “hold”. iMportant: This will not interrupt the rocking/
waving function. Press the on/off button below the speed/tilt angle display to
interrupt the rocking/waving function. Restart the timer by pressing the on/off
button below the time display. Unit will continue counting down to zero (0:00).
When the display reaches zero (0:00), you will hear the four (4) audible beeps
that indicate the count down function is complete and the rocking/
waving function will cease.
7. turning unit off:
a. To turn unit off, press the standby button. The temperature, speed/tilt angle
and time displays will be blank, the standby indicator light will illuminate. The
Incubating Rocking/Waving Shaker should be kept in standby mode when not
in use. To completely cut off power to the unit, disconnect the power cord from
the unit or unplug from the wall outlet.
opErating tipS
As a safety feature, a built-in program will shut power off to the motor if the tray is
prevented from rocking/waving, or the unit is overloaded beyond its recommended
weight capacity.
Built-in memory maintains the last used temperature, speed/tilt angle and time settings
during a power interruption.
7
P
rofessional
i
nCubating
r
oCking
/W
aving
s
haker
o
Perating
i
nstruCtions
Cont
’
D
