www.aebikes.com.au
|
|
page 011
Usage and maintenance of gearbox and controller
•
Regularly check whether the gearbox fixing screws are loose, and the lubricating oil level is between the upper
and lower tick marks. Please do not ride electric motorcycle if the gearbox is short of or without lubricating oil as
this may cause damage to the gearbox. After the running-in period, replace the lubricating oil every 1000KM
(lubricating oil grade: CL-5 85W/90). To replace the lubricating oil, firstly loosen the oil rule cap screw on the
gearbox, and then loosen the oil drain bolt to drain out the used lubricating oil. If there is no used lubricating oil
draining out, please clean the dirt on the magnetic core of oil drain bolt, and then fix it back on the gearbox, and
fill 120-150ml of lubricating oil into the gearbox through the oil filling hole.
• Regularly check whether the connection wires between motor and controller are loose, and whether the insulation
of the wires is in good condition.
• Regularly check whether the fuse is loose or melted.
• It is not recommended to ride your electric motorcycle in deep puddles. This may cause the motor to work
incorrectly.
•
It is not recommended to use a high-pressure washer to flush the motor and controller.
Illustration 8
8-1
Oil Rule Cap & Oil Filling Hole
8-2
Oil Drain Bolt
8-3
Gas Vent
