K11414;19/20
- 19 -
9. Notes
●
Do not disassemble this equipment or alter the internal circuits. Accidents such as a fire may be caused by the heat
generation associated with failure in operation.
●
Refrain from connecting or disconnecting cables and connectors while power is being supplied, otherwise troubles may be
caused.
●
Connect this equipment to a high quality power source unit that does not contain noise components.
●
Take appropriate measures to control the generation of noise if a power machine or other installations in the close
neighborhood of this equipment radiates noise, which might adversely affect this equipment.
●
Do not use this equipment in an environment subject to any temperatures other than that of the specifications or
condensation, or a place subject to considerable dust or constant vibration/impact.
●
When this equipment is not used for a long time, isolate the power from the equipment and remove the power cable and
external connection cables.
●
When an abnormal or failure condition is detected, immediately stop using this equipment, cut off the power supply, remove
the external connection cables and contact the dealer for inspection/repair.
●
More stable image (suitable for highly accurate measurement) can be obtained by leaving the equipment for 20 or 30 minutes
after the power is turned on.
●
The specifications and operational details described in the catalogues, manuals and others are subject to change for
performance improvement or other reasons without notice.
10. Specifications
[Specifications]
Imaging device
Progressive scanning, interline transfer CCD
2/3 inch in size
Unit cell size: 6.45
µ
m(H) × 6.45
µ
m(V)
Number of effective pixels
1390 (H)×1040(V) square grid pattern
Read out scanning
Horizontal scanning frequency: f
H
= 32.0KHz
Vertical scanning frequency:
f
V
= 30 Hz
Pixel clock frequency:
f
CLK
= 57.273 MHz
Standard sensitivity
400Lx at F22 *
(* Digital output with exposure time of 1/30 seconds and 512/1024 gray scale)
Minimum subject illuminance
1.5 Lx at F1.4
S/N
50dB and above
Video output signal
Progressive scanning: 30 frames / sec
Output signal:
Digital output: Complied with Camera Link (Base Configuration)
10 bit scale (57.273MHz × 2tap × 10 bit output)
Electronic shutter
1/23000 sec. to 1/ 30 sec. (no shutter) to 1/3 sec.
Trigger input
Two ways
・
Via 12pin connector
H=2.0 to 5.5V, L=-0.5 to 0.5V
・
Via cc1/Camera Link compliant (LVDS format)
Serial communication
Built-in UART, Asynchronous communication method, 9600bps
Lens mount
C mount
Power supply
DC12V±10%, 450mA (max)
Operation ambient temperature 0°C to 40°C (Shall be free from dew condensation an d frost.)
Storage temperature range
-30°C to 60°C (Shall be fr ee from dew condensation and frost.)
Anti-shock
70G
Anti-vibration
7G
External dimension
46(W) × 42(H) × 112(L) mm (excluding tripod attachment)
Weight
Approx. 260g