Operating mode
selection buttons
Start/stop button
Checking of Operations
After confirming the above, the installation is completed.
①Check the initial status
・Confirm that all lamps illuminate for one second after turning on the power switch.
Then only the operating mode lamps (4 lamps) will blink.
③Check the operation of fan（only for specification with fan ）
・While doing the check No. (ring is rotating), press the FAN button once.
*After pressing the FAN button, fan starts rotating and the lamp of the FAN button illuminates.
②Check the operation
・Press the MANUAL button.
Press Start/Stop button.
Confirm that the ring rotates and heater works properly
.
Pilot lamp (blue) blinks.
＜*CAUTION ＞
Heater starts glowing after the ring rotates approx. 360 degrees.
Fan button
(only for the specification with fan)
【Process】
【
Control Panel
】