・ Raising and fixing the shaft.
CAUTION
１．Loosen the screws.
３．Tighten the screws.
Correct screw positions
Shaft
Hole for the lock screw
２．Tighten the screw.
Tighten the lower screw first, and then tighten the upper screw .
When the screws comes at the correct positions
(as per the illustration below), tighten the lock screw.
M5 x 15 cap bolt (with spring washer): 1 piece
*Use the allen key wrench supplied.
Loosen the screws on the shaft with the L-shaped wrench, raise the shaft up, and tighten with the lock screw.
Check that the screws are in the
correct positions when the shaft is
raised.
When the shaft comes at the appropriate position, tighten these screws
starting from the lower screw to firmly secure the shaft.
Appropriate Shaft Position
A
B
*The distances A and B should be almost the same.
This screw prevents the shaft from
falling when the screws that fixes
the shaft becomes loose.
If the lock screw is not tightened, the shaft may lift
from the friction, resulting in tumbling of the product.
CAUTION
4
*The shaft must be secured tightly since insufficient tightening may cause the
unit to rattle.
*Never release your hands from the shaft until you complete this procedure.
If A and B are not in the same distance,
you will not be able to install the pipe cover
correctly.
