TD9300 Installation and Configuration Manual
Safety and Regulatory Information
9
© Tait International Limited September 2018
High Surface Temperatures
Caution
Hot Surface
The surfaces of the terminal can become hot during
prolonged operation. Do not touch these parts of the terminal.
LED Safety (EN60825-1)
This equipment contains Class 1 LED Products.
Isolation (EN 60255-5)
Models with isolated ports are tested in accordance with EN 60255-5 to a
level of 2.5kVDC (DC port) and 2kVAC (signal ports).
Caution
The RF connector is not isolated. On models where only the
signal ports are isolated, the DC port isolation must be achieved with the
use of an appropriately rated external power supply.
Equipment Safety
Installation and Servicing Personnel
The equipment should be installed and serviced only by qualified
personnel.
Antenna Load
Transmitting into a low VSWR will maximize the power delivered to the
antenna.
Notice
Do not disconnect the antenna from the TD9300 while it is
transmitting.
Load transients (switching or removing the load) can damage the
transmitter.