CNC-110A Series C-03/C-13 User's manual
5
έᚊཝҋજ̼ѣࢨ̳Φ
TAILY AUTOMATION CO.,LTD.
6. CONFIGURATION
SETTING
CNC-110AS is a multi-purpose design, to meet various requirements; additional settings are
configured to provide flexibility for additional applications.
In the READY mode, pressing the following keys combination as
(6.1. ~6.9.)
all the parameters
can be changed.
6.1. Zero point
Select the winding spindle shaft is need or not having a zero point.
With zero point
：
. (Use with zeroing disc. See section 10.1.)
Without zero point
：
.
6.2. Braking mode
The SINGLE MODE is to brake until the end of each winding step
.
The DOUBLE MODE is to brake a short period when the turns number match the SLOW STOP
TURNS, then winding to the end by LOW speed, and brake another time to finish the step
.
Single mode
：
. Double mode
：
.
6.3. Counting mode
The RELATIVE MODE is to reset the TURNS COUNTER to zero without any consideration
before start winding.
The ABSOLUTE MODE is to reset the integer portion of TURNS COUNTER to zero, but keep
the decimal portion unchanged.
Relative mode
：
. Absolute mode
：
.
6.4. Starting mode
ON-OFF mode means when press the foot switch, the motor start winding, and when you
release the foot switch, the motor stop winding immediately.
TRIGGER mode means when press the foot switch, the motor start winding, and if you want to
pause the motor, you have to release the foot switch then press it again.
The
key on the front panel always as the Double start mode.
Single start mode
：
. Double start mode
：
.
6.5. Counting unit
You can choose 0.1 or 1 turns as your count unit. After you choose the unit, the TURNS
COUNTER, and the winding parameters setting will use it as their basic unit.
Unit = 1
：
. Unit = 0.1
：
.
6.6. Brake holding times
In READY mode, press
keys, to set the holding times for brake.
[Setting range 0.1~9.9 sec], if you set the braking time as 0.0sec, the controller will used the
default time 0.3sec.
