AG-1000 User’s Manual
SMS Alert Gateway
All contents are subjected to change without prior notice
Rev 7.3
Page 6 of 27
Copyright © 2005 Taiko Network Communications Pte Ltd
(6) Ethernet Port (RJ45), “LAN”
This is for Ethernet connection. The pin layout is shown as follow:
1: E_TX+
2: E_TX-
3: E_RX+
6: E_RX-
To connect with any LAN switch or hub, a UTP straight cable is required. A UTP cross cable is
used to connect with a computer Ethernet port directly.
2.2 Hardware Setup
Connect the SMS alert gateway as the following diagram:
Insert a SIM card into the SIM card tray and turn on the power supply. The Signal LED,
“STATUS” light up but will not be flashing during power cycle. After 10 seconds later, it starts to flash,
indicating that SIM card is detected within GSM coverage. Otherwise, the LED will not flash.
Sim Card
-
Ensure that the SIM card is not locked by any PIN.
-
Do not use a prepaid SIM card.
-
Ensure that there are no SMS or phone number stored in the SIM Card.
Connect Ethernet (RJ45) port, “LAN” to the computer for configuration. After configuring the
gateway, unplug the cable from Ethernet port. The gateway can be installed in existing TCP network, so
1 8
