20
2.6.2 Carrier(s) Setting
Setting up
→
“Set up status”
→
“Channel number”
→
“Frequency point”
→
“audio setting”
1) Enable/disable current carrier
a) Use the “ / ” button to enable or disable the
current carrier;
b) Use the “MENU” button to save;
If “Enabled”:
•
Press the “MENU” button to setup the current carrier;
•
The frequency of the current carrier will be displayed.
(figure 1.5 shows the band allocation).
If “Disabled”:
•
Press the “MENU” to return to the upper level menu.
2) Channel number configuration
a) Press the “MENU” button at this interface to go to
the channel number configuration, as shown in the
following figure;
b) Use the “ / ” button to increase or decrease the
channel number. The exact channel number
depends on the audio quality (see section 1.2.5).
c) Use the “MENU” button to the save channel number
setting.
3) Audio quality setting
a) Go to the audio quality setting interface;
b) Press the “MENU” button to switch channel number
(in the case of more than one channel).
“Audio input:” indicates the current channel
corresponding to the HCS-5100M transmitter audio
input channel;
c) After having selected channel number(s), use “ / ”
to adjust audio quality.
Audio mode includes
:
→
“Standard MONO”
→
“Perfect MONO”
→
“Standard STEREO”
→
“Perfect STEREO”
The selectable audio quality depends on the channel
number (refer to section 1.2.5).
4.) Save settings
a) Use the “MENU” button to save setting;
b) Go to the next carrier configuration,
c) Repeat above until all carriers have been set up.
2.6.3 Channel Name Setting
Assign a language name for every channel.
a) Use the “MENU” button to switch the channel
number;
b) Use the “ / ” button to adjust the current channel
name (for selectable language name refer to
section 7.7).
2.6.4 Audio Input Sensitivity
“Input sensitivity” includes 2 submenus:
•
“All”
= adjust all channels input sensitivity
•
“Per Input”
= adjust each channel input sensitivity
separately
Note
:
Carriers of “Slave” unit will be set via “Master” unit.
