3.6.2 Installation
3.6.2.1
Installation of N-series conference unit
■
Stand-alone installation
a. Cut holes in the table according to the positioning
diagram (figure 3.20);
b. Put the conference unit with the cables into the
hole. Fix the unit with the black M3 Phillips screws
(figure 3.21);
c. Stick PVC to it.
Figure 3.20 Dimension diagram of N-series conference
unit (unit: mm)
Figure 3.21 Positioning diagram of N-series conference
unit (unit: mm)
Figure 3.22 Installation diagram of N-series conference
unit (unit: mm)
■
Assembly installation
a. Cut holes in the table for the first unit according to
the positioning diagram (figure 3.21);
b. Make sure that the distance between the center of
the two adjacent holes is 111.4 mm (figure 3.23),
and repeat step a to cut holes for the adjacent
unit(s);
c. Put the conference units into the holes, with the
cables, according to the mounting feasibilities
existing on site. Fix with black M3 Phillips screws;
d. Stick PVC to each unit.
Figure 3.23 Positioning and assembly installation diagram of several N series conference units (unit: mm)
63
