3.3.2 Installation
3.3.2.1
Installation of M-series discussion unit
a. Cut a hole in the table according to the dimensions
in figure 3.6 (unit: mm);
b. Put the discussion unit into the hole and drill four
Ø 2 mm holes with 10 mm depth at the positions
P1 to P4 of the fixing screws;
c. Run the two cables - mounted laterally on the
discussion unit - according to the mounting
feasibilities existing on site.
d. Put the discussion unit into the hole and fix it with
screws at P1, P2, P3 and P4.
Figure 3.6 Fixing hole positioning diagram of M-series
discussion unit (unit: mm)
Figure 3.7 Installation diagram of the M-series
discussion unit
3.3.2.2 Installation of the protective cover of
M-series discussion unit
If not in use for a long time, just pull out the microphone
and put on the protective cover:
a. Hook up the protective cover on the left side;
b. Then press the protective cover tightly on the right
side.
Figure 3.8 Installation diagram of the protective cover of
M-series discussion unit
3.3.2.3
Dismounting the protective cover of the
M-series discussion unit
a. Prepare a straight screwdriver;
b. Insert the straight screwdriver into the gap at the
right lower side of the protective cover and rotate
the screwdriver by 90 degrees, the protective
cover will be separated from the conference unit.
Figure 3.9 Dismounting the protective cover of M-series
discussion unit
38
