Tahoe 4681, User Manual

Page: 26 / 52

18
Tahoe 4681 (4-port G.shdsl.bis/FastEthernet modem card)
route del < address >
– removes route to the specified IP address
route del -net < address > netmask < network mask >
– removes route to the speci-
fied subnet
route del default
– removes the default route
snmp
The snmp command is used to configure the SNMP (Simple Network Management Protocol)
support. It has following syntax:
snmp – shows current settings:
Tahoe> snmp
SNMP on
Read community: public
Write community: private
SNMP host1: <any>
SNMP host2: <disabled>
SNMP host3: <disabled>
Tahoe>
snmp on
– enables SNMP support
snmp off
– disables SNMP support
snmp rdcomm
<
community
>
– sets the read community – the password used to read the
SNMP parameters
snmp wrcomm <community> – sets the write community – the password used to write the
SNMP parameters
snmp host1
<
address
>
snmp host2 < address >
snmp host3
<
address
>
– allows setting of up to 3 addresses, from which the SNMP ac-
cess will be permited. Entering 0.0.0.0 allows access from any address, while 255.255.255.255
disables an entry (entering 255.255.255.255 in all three positions is equal to disabling the
SNMP service)