10
Active Balance - Cool Blue Balancer
Error Messages
Error will be indicated by the STATUS LED. The error
indication will show for 10 seconds and then the
balancer powers off. Press the MODE button while
an error is being indicated to clear the error and
connector’s status.
Master-Slave Mode
The balancer should be set to Master when it is
operated singly. For slave mode, please refer to
Other Balancer Configuration
. (Below)
Other Balancer Configurations
There are two ways of using two Tahmazo T6B
Max balancers simultaneously for balancing up
to 12 cells lithium cell-pack.
Configuration 1 – ‘Dual Battery Connection’
(See Figure 1)
• Switch one T6B Max to the ‘Master’ mode,
and the other balancer to ‘Slave’ mode.
• Connect the ‘Master’ T6B Max Balancer’s
data interface cable to the charger.
• Connect the (+) positive (red) input cable of ‘Master’
T6B Max Balancer to the charger’s (+) positive
output connection. Connect the (–) negative (black)
input cable of ‘Slave’ T6B Max Balancer to the
charger’s (–) negative output connection.
• Connect the (–) negative (black) input cable of ‘Master’
T6B Max Balancer and (+) positive (red) input cable
of ‘Slave’ T6B Max Balancer to a charger as shown
in Figure 1.
• Connect the network cable between two balancers.
• Connect the lithium battery pack’s output connectors
and balancing connectors to ‘Master’ Balancer and
‘Slave’ Balancer
in order
within
12 seconds
. (If the
lithium battery pack is not connected to ‘Slave’
Balancer within 12 seconds, ONLY the ‘Master’
Balancer will work singly.)
• The charging and discharging of the lithium battery
packs connected will be according to the instruction
of the charger/discharger.
