15
Child Seat Assembly
Î
y
If you did not order a child seat, you may skip forward to the next
section.
Î
y
If you received your child seat pre-assembled, you may skip forward
to step 3.
Î
y
On the underside of the seat bottom there are two latches which
you need to pull, either separately or together, to complete certain
actions. It is important to understand how to use these properly to
avoid damaging the seat.
NOTE
Step 1: Assembling the seat anchor
1.
Insert the anchor on the frame’s metal tube as shown
FIG 20
. Attach the
second part of the anchor on the opposite side and tighten the two parts
using the three screws provided
FIG 20
.
Step 2: Installing the seat
1.
Insert the anchor into the slot in the seat’s backrest by sliding the seat onto
the anchor as shown
FIG 21
2.
Pull the internal latch located on the underside of the seat bottom, attach
the rear part of the seat buttom to the frame as shown and release the latch
FIG 22
. The two rear bolts will lock into position and you will hear a “click”
3.
Pull the external latch located on the underside of the seat bottom, secure
the front part of the seat bottom to the frame as shown and release the latch
FIG 23
. The two front bolts will lock into position and you will hear a “click”
4.
Test the Child Seat to ensure it is attached firmly to the Cargo Compartment
Step 3: Attaching the padding
1.
Position the padding on the seat and backrest as shown.
FIG 24
.
Step 4: Assembling the harness
1.
Disconnect the bottom part of the harness by pressing on the two sides of
the crotch buckle while simultaneously pushing the safety button on the
crotch buckle.
2.
Insert the lower strap loop onto the two horizontal plastic pins in the seat:
first insert one side of the loop and then the other side. If needed, use a flat
screwdriver to push the strap onto the plastic pin
FIG 24
3.
Thread the harness straps through the slits in the shoulder pads as shown
FIG 25
Summary of Contents for Taga 2.0
Page 1: ......