11
the cam lever with the other hand to adjust the mechanism. Rotating the
cam lever clockwise increases clamping force; rotating it counterclockwise
reduces clamping force. Make sure that you rotate the lever clockwise until
the washers are fixed to the dropout firmly. Less than half a turn of the lever
can make the difference between safe clamping force and unsafe clamping
force
FIG 06
.
4.
Close and secure the quick release mechanism by closing the lever 90 degrees
so that it is parallel to the wheel. Note the “close” engraving on the lever. You
should use force to close the lever. If closing does not require force, it means
that the clamp is not tight enough
FIG 06
.
Riding with an improperly adjusted wheel quick release can allow the
wheel to wobble or fall off the tricycle, which can cause serious injury or
death. Therefore, it is essential that you:
1.
Ask our support department to help you make sure you know how
to install and remove your wheels safely.
2.
Understand and apply the correct technique for clamping your
wheel in place with a quick release.
3.
Each time, before you ride the tricycle, check that the wheel is
securely clamped.
!
WARNING
Step 3: Assembling the left steering post
1.
Insert the steering post to its location and make sure it is positioned at the
correct angle and that the location pin is inserted into its slot, as shown
FIG 07
2.
Make sure the cables go directly from the frame to the handles, and are not
twisted.
Secure the steering post in place by closing the quick release lever
FIG 07
. If
it is too easy to close, adjust the nut and close the lever again.
Step 4: Assembling the main frame
1.
Hold the rear frame with your right hand, the front frame with your left hand
(using the left handlebar) and gently attach the T joint half profile onto the
front frame’s main tube
FIG 08
. Try not to damage the paint while doing so.
2.
Align the holes of the T joint half profile with the holes in the front frame and
insert the quick release screws through the holes
FIG 08
. Make sure the
curved washer on the quick release screw is in the correct position.
3.
Secure by screwing the nuts onto the quick release screws from the other side
of the frame
FIG 08
4.
Tighten the nuts as much as you can (shake the frame a bit to make sure
Summary of Contents for Taga 2.0
Page 1: ......