16
Treble
You can adjust the treble level.
Press Treble - button to decrease the amount of high frequencies by -1dB.
Press button to increase the amount of high frequencies by +1dB.
Reset Tone to Factory
Press the Reset button to reset Bass and Treble to factory settings (0).
Note!
Increasing the amount of bass / treble at high volume levels can damage this
system. This may void your warranty.
MUTE
During playback press this button to stop audio output (no sound will be audible) – the
RED status LED will be flashing slowly. Press it again to recover the audio signal out
-
put back - the RED status LED will turn off.
Note!
The following functions are not active in the MUTE mode: Volume Regulation,
Tone Regulation (Bass/Treble), Reset Tone to Factory.
AUTO STANDBY
Press the Auto Standby ON button to enable the standby feature – the system will be
turned to the standby mode after around 15 minutes of inactivity. Press the Auto Stand-
by OFF button to deactivate this feature.
Note!
When the system is in the standby mode then all LEDs are off.
The system will switch from the standby mode to the Power ON mode:
- after a signal is detected on the LINE input or;
- after the Power ON button is pressed.
The YELLOW (Line In) status LED will indicate that the system is activated.
Confirmation of receiving the command from the remote controller
Each time any button on the remote controller is pressed and the command is properly
received by the system – the RED status LED will flash once – when a button is kept
pressed down the RED status LED will be flashing quickly.
Note!
This does not apply to Power ON/OFF, BT, LINE and MUTE buttons.
MEMORY
When power is connected the RB-1650BT automatically turns on with the previously
set volume and tone levels. Restoring power brings the speaker back to life automati-
cally.
Bluetooth
®
Connection
1. After the system is switched on - the built-in
Bluetooth
®
receiver is waiting to be
paired with a
Bluetooth
®
source. The BLUE (Bluetooth) status LED is blinking.
Note!
If no device is paired within a few minutes then the BLUE (Bluetooth) status LED
will turn off.
2. Select
Bluetooth
®
on your audio source (smartphone, laptop etc.) and start scan-
ning for available
Bluetooth
®
devices.
After a short time “TAGA RB-1650BT” will appear on the screen of your audio source.
3. Select “Pair” on your audio source to connect with the system. After the operation is
successful the BLUE (
Bluetooth
®
) status LED will light continuously.
4. The RB-1650BT will now be ready to play your music wirelessly within a range of
approximately 7 meters.
