Operation
Setting the Clock
Setting the Clock Manually
Note!
You can set the Clock in the Normal Standby mode only.
1. In the Standby mode, press and hold the
CLOCK
button to activate the Clock setting
mode, [CLOCK SET] will be displayed, then the time format [24] or [12] will blink.
2. Set the 12/24 hour format using
VOL +/-
, ►l, l◄ on the remote controller, or
VOLU-
ME
Regulator, ►►l, l◄◄ on the front panel.
3. Press the
CLOCK
button, the hour indicator will blink.
4. Set the hour using
VOL +/-
, ►l, l◄ on the remote controller, or
VOLUME
Regulator,
►►l, l◄◄ on the front panel.
5. Press the
CLOCK
button, the minute indicator will blink.
6. Set the minute using
VOL +/-
, ►l, l◄ on the remote controller, or
VOLUME
Regula-
tor, ►►l, l◄◄ on the front panel.
7. Press the
CLOCK
button, the built-in clock starts operating.
Note!
• To exit the Clock setting mode without storing, press the button.
• If no button is pressed within 10 seconds, the CD-Receiver exits the Clock setting
mode automatically.
• If a power failure occurs or the CD-Receiver is disconnected from the electrical
outlet, the Clock setting will be lost.
Setting the Clock Automatically
When the CD-Receiver is tuned in the DAB/RDS station for the first time and when
the Clock is not set, the CD-Receiver can synchronize with the time transmitted by the
DAB/RDS station (with CT information) automatically.
After that, Press the
INFO
button for over 2 seconds:
»
[CT SYNC] will be displayed and the CD-Receiver will read the DAB/RDS time.
»
If no time signal is received, [NO CT] will be displayed.
Display the Clock
In any Input mode, press the
CLOCK
button to display the time for a few seconds.
INPUT selection
By rotating the
INPUT
knob on the front panel or pressing one of the function buttons
on the remote controller, select which audio input (source) you want to play.
Sequence of changes via the
INPUT
knob: DAB → TUNER → BT MODE→ DISC
→ USB → AUDIO IN → AUX1 → AUX2 → PHONO → OPTICAL1 → OPTICAL2 →
COAXIAL → NETWORK MODE
Automatic Standby Mode
To save energy, the CD-Receiver will automatically switch to the Normal Standby mode
and then after some time to the ECO Power Standby mode, in case:
- no buttons are pressed within approximately 15 minutes after the playback is stopped.
- the output sound is muted (MUTE) or the volume level is set to minimum (VOL MIN)
for approximately 15 minutes.
Note!
In some cases this feature may not be activated.
19
