Taga Harmony HTA-700B v.3-USB, Instruction Manual

Page: 11 / 20

Operation
1. Plug the Power Cable to the amplifier and into the electrical outlet.
2. Turn on the amplifier – press the Power Switch (the Power Switch should be in the
down position). The status LED located on the Volume Regulator should
turn red in a few seconds. If it does not, it means that the amplifier is working
under an abnormal condition (a protection mode) – turn off the power, unplug the
Power Cable and check whether some of the cables are not short circuited. After
fixing the cables turn the amplifier on.
3. By pressing the Input Selector button on the front panel or pressing one of input
selector button on the remote controller, select which audio source you want to
play. Make sure the audio source is properly connected to the rear panel inputs.
The selected source is indicated by one of LED indicators on the front panel.
4. Switch on your audio source and start playback.
5. Regulate volume on the amplifier to adjust level of sound.
Note! High volume levels can damage this amplifier and/or speakers. This may void
your warranty.
Note! Check “Additional Information” for other useful operating instructions.
Headphones connection:
When headphones (not supplied with this product) are plugged into the headphone
output (Headphones) the transmission of sound to the speakers and PRE OUT is
switched off. The speakers and PRE OUT are again active after you disconnect the
headphones.
The volume of the headphones is regulated by the Volume Regulator (front panel and
remote controller).
All sound regulations (Bass / Treble) will affect the sound transmitted to the
headphones.
Note! Listening at high volume can cause hearing damage.
Volume Regulator (front panel and remote controller):
Using the Volume Regulator on the front panel or down ▼ and up ▲ buttons on the
remote controller, you can adjust the sound volume from minimum (the knob – max
counterclockwise) to maximum (the knob – max clockwise).
Note! Distortion and sound quality worsening may occur when the knob is in the
maximum position. It may damage the amplifier or speakers. This may void your
warranty.
MUTE (remote controller):
During playback press this button to stop amplifier audio output (no sound will be
audible in speakers, headphones nor through the PRE OUT).
Press the Mute or volume regulation buttons on the remote controller to recover the
audio signal output back.
11