Magnetic Stripe Reader and Barcode Scanner
The Magnetic Stripe Reader (MSR) and Barcode Scanner modules are optional components.
Contact your representative for ordering information.
Installing the Module
1. Power off the TAG GD700. See “Powering Off the Device” on page 20.
2. Remove the snap-on module connector cover. See “Removing the Snap-on Module
Connector Cover” on page 32.
3. Align the module correctly. The Barcode scanner sensor must be facing the front of the
device.
4. Align connectors on the module and the device.
5. Insert the device over the connector and press down. An audible click sounds when the
module is installed correctly.
6. Secure the module and the TAG GD700 with the screws.
Figure 74. Installing the Screws
Figure 73. Installing the Module
TAG GD700
Page 50 of 68
