input management
|
17
16
|
input management
digital input
A digital source may be selected by pressing
one of the six digital input keys on the
remote. Alternatively, it may be selected from
the front panel by pressing the
INPUT digital
button once or repeatedly until the desired
source is shown in the display window
(1)
.
1. Digitising an analog input signal only affects the signal routed to the
DIGITAL OUTPUT
s, i.e. it does not affect the signal sent to your
power amplifier.
2. The sampling rate indication is overwritten by the number of the selected station preset, if the optional Digital Radio Upgrade is installed
in your DPA32R.
You may listen to the analog
tape
monitor by pressing the
tape key on the remote or the tape
button on the front panel of the
DPA32R
DAB
. Selecting the tape
monitor does not change the source
routed to the
ANALOG OUTPUT tape out
.
Pressing either the
tape
button or key again
will restore the last selected audio source
as the active audio input source.
If you do not use the ‘tape monitor’ function
then you can use the
ANALOG INPUT tape
in
as an additional input but you need to
remember that selection of any of the inputs
will direct the selected input signal to the
ANALOG OUTPUT tape out
, while selecting
the tape in input will not change the tape
out output signal from the other input
selected, i.e.
tape in
is never directed to
tape out
.
tape + tape monitor
The selected digital
source signal is
automatically connected
to all
DIGITAL OUTPUT
sockets.
A fixed level analog
signal is also connected to
the
ANALOG OUTPUT tape
out
sockets.
digitising an analog input for recording
on a digital recorder, e.g. Minidisc
(1)
In addition to the
tape out
, a digitised
signal of the selected input can also be
routed to the digital sockets labelled
DIGITAL OUTPUT
so that it can be sent to a
digital recording device. The sampling rate
has to be set according to the connected
recording device, for details see page 26.
Digitising an analog input does not affect
the signal routed to the
ANALOG OUTPUT
s.
The selected sampling rate is shown in the
display (top left). The conversion can also
be switched off, in this case the display
indicator stays blank
(2)
.
display of sample rates
The sample rate indicator at the top left of
the display window shows the active
sample rate for the digital source
(2)
. The
sampling rate cannot be changed as it is
defined by the digital recording.
GRR00780.02-GB DPA32R v1.07.4 11/10/01 2:26 pm Page 16
