Please make sure that the voltage in your
country is identical to the voltage stated on
the rear panel of the DPA32
DAB
. Check that
the power button is out so that the power is
off when you later plug in
(1)
.
Please make sure you have
made all connections, as
explained below, before you
switch the DPA32R
DAB
by pressing
the power button in on the front panel. The
blue power LED will come on, the front panel
display window will light up and a few
seconds later show
SELFTEST
and
TAG
McLaren
, then the software version number
displayed information
|
13
power connection
switching on
standby
12
|
switching on and off
1. The power button is a latching switch. One press will hold it in; the next will release it.
2. The descriptive name can be changed by the user, see page 29.
3. The output is muted when the power is switched on to allow the voltages to stabilise. This protects the internal components on your
DPA32R
DAB
, amplifier and loudspeakers and prevents unpleasant switching noises from upsetting your listening experience.
(such as ‘V1.07.4’) and a descriptive name,
such as DPA32R
(2)
. The mute LED will
illuminate briefly
(3)
.
The DPA32R
DAB
has a standby
mode , which can be entered
using the
standby
key on the
remote control or by keeping
the
mute
button on the front
panel pressed for more than
three seconds. The blue power LED will dim
and the front panel display window will be
switched off. Normal operation may be
resumed by pressing any front panel button
or remote key.
3 Seconds!
status after switching on
Has the DPA32R
DAB
been switched off, then
the last used input is re-selected when the
DPA32R
DAB
is switched on again.
display during switching on
A few seconds after switching on the
DPA32R
DAB
, the front panel display will
show (after completing the SELFTEST and
after finishing a station scan, if the Digital
Radio option is installed) the last selected
input and the volume setting, as shown
below.
The display layout shown will vary if the
optional Digital Radio module is installed.
front display
changing the brightness
The display brightness can be
changed in 3 steps (
low
,
mid
and
high
) or switched off
completely. Press display on
the front panel or the remote
to scroll through the four options. You can
customise the brightness associated with
low
,
mid
or
high
, for details see page 29.
If the display is switched off, it can be set to
switch on for a short time if the display
content changes, for example, if a key or
button is pressed. See page 29 on how to
customise the length of time the display will
temporarily be switched on.
Do not connect your
DPA32R
DAB
to an AC supply
outlet until you have made all
connections, as described below!
GRR00780.02-GB DPA32R v1.07.4 11/10/01 2:26 pm Page 12
