TAG
Heuer Timin
Page 5 / 8
2. Battery Charging
Each device has a Lithium-Polymer battery with supply 2100 mAh. Those batteries may be charged
with our charger HL540-10 or other 12V charger with a minimum of 800 mA.
For charging the battery we advise you to use our OEM TAG Heuer charger
Using another model may cause some trouble or harm the device.
-
For charging, turn off the system.
-
Connect the charger on the mains
-
Plug the charger into the device
-
The red LED will be on during the charge
IMPORTANT :
Always charge the devices by temperature above 32°F (0°C) and below 86°F (30°C)
The red LED lights during the charging process, when fully charged, the red LED shuts down and the
green LED will light on.
For a fully charged Battery it may take approx. 5 hours (for a completely discharged battery)
WARNING
Never
connect the terminals of the battery in short-circuit.
To avoid
keeping the battery pack fully loaded or completely discharged for a long period,
which reduces the lifespan of the battery. In the case of prolonged non-utilization of the
battery pack, it is necessary keep the system in a dry room, after a normal discharge.
In case of a reduced capacity of the battery pack, even after the load, leave the system ON a
whole night to obtain a complete discharge, then recharge the battery pack completely.
Renew the battery pack if the problem continues.
3. Software Update
With the Firmware (already used with the Chronoprinter 545 and the Minitimer HL440) able you to change
the transmission mode and Update your device.
New firware for the HL 675 are available free of charge on our website:
www.tagheuer-timing.com
For this application you need :
The RS232 cable (HL605-10)
A computer fitted with a D-Sub9 RS232 Output
The software « FirmwareManager.exe »
How to proceed
1. With the radio switched « OFF » connect the external power Connect the RS232 between your
computer and the HL 675
2. Run «FirmwareManager.exe »
