Tacx NEOBIKE, User Manual

Page: 15 / 368

- 13 -
EN
E. MOUNT THE CONTROL PANEL AND HANDLEBARS
15. Place the cap T8010.05 in the handlebar rail (C2).
16. Mount the control panel and handlebars on the handlebar rail (C2). Make sure the cables remain free.
17. Fix the panel with a 6 mm allen key.
18. Set the handlebar height and distance with bolts C3 and C5 with a 6 and 8 mm allen key. Or replace the
bolts by the handles T8015.15 and T8015.16. Max. height is 26 cm and max. distance is 15 cm, please do
not exceed this limit. Consult the correct posture on page 8.
19. Adjust the angle of the handlebars, if desired:
a. Remove the handlebar cover (C1) with the Torx 20.
b. Remove the 4 screws.
c. Set the needed angle and fix the handlebars with the 4 screws.
d. Position the handlebar cover (C1) and fix with the Torx 20.
G. MOUNT THE AIR FANS OR TABLET MOUNT
Please note the air fans include a tablet mount.
20. Place the air fans (B1) or tablet mount (T8010.16) on the panel.
21. Fix the fans with the torx 20.
22. If desired, you can change the angle of the air fans with knob B2.
23. Position the power cables for the display and fans.
H. PLACE RUBBER MAT
24. Place the rubber mat on the phone surface.
J. PLACE YOUR TABLET
25. Position your tablet, if desired, and tighten with the rubber strip.
26. Plug the power cable of your tablet into the USB ports under the panel.
Tacx is not liable or responsible for damage caused to your devices due to incorrect mounting of the tablet holder.
K. CONNECT TO MAINS POWER
Choose to train with or without mains power. When not connected, it will generate its own energy and is
powered as long as it is cycled on. The NEO Bike Smart will have the same features and specifications
(except Descent Simulation) as it would have with a power supply connection.
OPTIONAL: Customize the bike by mounting your own saddle, handlebar tape or bottle cage as instructed
by the supplier. Please check the Tacx support website for instructions.
USE OF HANDLES: The handles T8015.15 and T8015.16 may be used to set the height and horizontal
position of the seat post and the saddle instead of a 6 and 8 mm allen key. This is especially handy when
you have to set this regularly; for example, when various persons use the NEO Bike. You can do so by
replacing the bolts; replace C5 and D6 by the T8015.16 and the C3 and D4 by the T8015.15.