6
6. AnyLink’s LED will turn on. Wait 5 seconds and AnyLink will
sound three tones
•
•
•
to indicate the Alternate Channel Mapping
mode has been entered.
7. Release the rudder stick. AnyLink should sound two tones
•
•
to
indicate the mapping has been changed. The chart below shows
how the channels should now be mapped
depending on the type
of Tx that is connected
.
IMPORTANT:
Make sure all servos are
connected to the proper receiver slot accordingly.
CHANNEL 2
Elevator
Throttle
CHANNEL 3
Throttle
Aileron
CHANNEL 1
Elevator
Aileron
CHANNEL 4
Rudder
Rudder
FUTABA and HITEC
ALTERNATE CHANNEL MAPPING
JR and SPEKTRUM
See page 7 for complete failsafe details.
8. Check to see if all channels are properly mapped between the
Tx and the model’s flight system. If NOT, repeat steps 1 through 7
above to return AnyLink to its “NORMAL CHANNEL MAPPING” as
explained on page 4 which is indicated by AnyLink sounding one
tone when power is applied.
NOTE:
If AnyLink’s Alternate Channel Mapping mode cannot be
entered for any reason, changing the servo connections at the Rx
to properly match the controls of the Tx can still allow AnyLink to
function properly with your Tx.
