4
ANYLINK OPERATION
IMPORTANT!
Make sure the Tx battery is at full charge
prior to operation. Replace weak alkaline batteries, or
fully charge rechargeable batteries before attempting a flight. To
avoid accidental power or signal loss which would result in loss
of control of the model, make sure all connections are solid
physically and cannot easily become dislodged at any time.
The factory default setup for AnyLink is for all output channels to
be mapped identically to the signal from the host transmitter. i.e. All
Tx stick movements should result in proper servo movements. It is
possible to manually re-configure AnyLink for alternative channel
mapping, if desired (explained in next section).
IMPORTANT:
To
set a specific failsafe position for throttle with JR and Spektrum
transmitters, the alternate channel mapping mode must be used
(skip to page 5). For normal operation:
1. Move the Tx throttle stick to minimum. Leave all other sticks at center.
2a.
Futaba and Hitec transmitters:
Turn the Tx power switch ON.
AnyLink should sound one beep, and AnyLink’s LED should turn
on. Skip to step 3.
2b.
JR and Spektrum
transmitters:
Connect the cable’s
“Power Plug” to the Tx
charge jack as shown.
AnyLink should sound
one beep, and AnyLink’s
LED should turn on.
WARNING! Do NOT turn the JR or Spektrum Tx power
switch to the ON position at any time!
This will cause
AnyLink to stop sending signal to the Tactic Rx and result in a loss
of control of the model! The JR/Spektrum Tx power switch should
ALWAYS remain in the OFF position when controlling a model
with AnyLink.
Signal plug
(DSC)
Power plug
(Charge jack)
JR/Spektrum Tx
