33
The First Screen is
described in detail on
p.40.
navigating the menus
The First Screen
When you turn on your system, the “First Screen” will be visible in the front panel display. This first
screen gives you access to your entire Boz system through four portals:
AMPS:
Access to menus for setting individual
BOZ-2200 module settings; access to
individual amplifier controls.
GROUP:
Access to menus for selecting groups and
for editing the group settings of your Boz system.
PING:
Not a menu option, but rather is a command.
This command allows you to ‘ping’, or send out a
signal to verify how many BOZ-2200 modules are connected to your BOZ-216 control unit. The
front panel of each BOZ-2200 module will display the AMP number designated to it.
MENU:
Access to menus that control system wide settings, such as time, display illumination, “BOZ
Wheel” sensitivity, etc...
1. Move the cursor over the modifiable menu option and CLICK the rotary knob. When this ac-
tion is executed a check mark will appear on the right side of the menu option.
2. To increase a parameter’s value, turn the rotary knob clockwise. The check mark will disap-
pear and a dot will be displayed in the upper right corner. To further increase the selected
parameter, keep turning the rotary knob clockwise. In many cases you can push the knob in
and hold it down for fast parameter changes.
3. To decrease a parameter’s value, turn the rotary knob counterclockwise once to display the
check mark.
4. Turn the knob once more time counterclockwise to display a dot in the lower right corner. To
further decrease the selected parameter keep turning the rotary knob counterclockwise. In
many cases you can push the knob in and hold it down for fast parameter changes.
5. After the change is completed turn the knob clockwise once to display the check mark.
6. To finish editing the selected parameter, CLICK the knob once and the system will return to
normal mode.
Using the Optical control Knob
The optical rotary control knob can be turned clockwise and counter-
clockwise and can also be pushed in. While being turned or pushed in,
the rotary control knob produces distinct clicks. The clicks are designed
to give feedback to the user by indicating when changes take place.
The rotary control knob is used to scroll through menu options, select
menu options, and to set or modify system parameters.
Throughout this manual term “CLICK” refers to an action performed by
the rotary control knob; “CLICK” means that the knob was pushed in. To
select a menu option, turn the rotary knob to position the cursor over
the desired menu option and then click to select. If the menu option
consists of a modifiable value that you desire to change, follow the
example below.
b
o
z
n
a
vig
a
tio
n
Summary of Contents for BOZ 216
