CAUTION
When changing from foot pedal controls to manual controls, the machine starts automatically. The
stroke rate corresponds with the stroke rate set on the stroke rate controller (19).
9.6 Making inside cuts
This scroll saw allows inside cuts in workpieces without damaging the outside or the circumference of
the workpiece.
1.
Remove the saw blade (23) as described in 9.3.
2.
Drill a hole into the workpiece.
3.
Place the workpiece with the drilled hole over the open- ing of the table inlay (27) on the saw table (6).
4.
Install the saw blade (23) through the drilled hole in the workpiece and set the blade tension.
5.
After completing the inside cut, remove the saw blade (23) from the blade holders (as described in 9.3).
6.
Remove the workpiece from the table.
9.7 Miter cutting (fig. 14)
WARNING
Be especially careful when making miter cuts. The angle of the saw table makes it easier for the
workpiece to slip. There is a danger of injury.
1.
To carry out miter cuts adjust the distance of the blade guard for worktable accordingly.
2.
Swivel the saw table by loosening the locking lever (15) and tilting the table (6) to the desired position.
3.
Tighten the locking lever (15)
9.8 Flexible Driver attachment (fig 17, 18, 19)
1. Run-In before Operation
For optimum performance, allow your new Flexible Driver attachment to run at high speed on your
rotary tool in a vertical position for 2minutes before use.
2. Disengagement of the Flexible Driver
The flexible shaft may become disengaged if the motor of your rotary tool is not elevated Higher than
the working end of the Flexible Driver.
3. Flexible Shaft Lubrication
The Flexible Driver should be lubricated after every 25-30 hours of use. To lubricate, Unscrew the
Flexible Driver assembly from the motor housing. Pull the center core out of the Flexible Driver
assembly. Wipe a very thin film automotive wheel bearing grease on to the center core and reinsert it
back into the shaft. To prevent damage to tool do not over grease shaft.
Too much grease will cause the unit to overheat.
Reattach the Flexible Driver to the rotary tool.
WARNING :
Must put the Flexible Driver back to the clip(fig 18, 54) when
you are done.
10. Electrical connection
The electrical motor installed is connected and ready for operation. The connection
complies with the applicable VDE and DIN provisions.
The customer
‘
s mains connection as well as the extension cable used must also
comply with these regulations.
