8. Assembly
WARNING
Danger of injury! Disconnect the mains plug on the scroll saw before all assembly work.
8.1 Installing the depressor (fig. 6, 7)
NOTE:
Before assembling the depressor (25), the saw blade pre-in- stalled at the factory (23) must be
removed (see 9.3).
1
．
Remove the saw blade (23) as described in 9.3.
2
．
Remove the depressor (25) from the saw blade guard
3
．
(5) by loosening the screw (26) completely (see fig. 6).
4
．
Insert the holder (4) into the opening (see fig. 7).
5
．
Fasten the holder (4) with the knurled screw (3).
6
．
Install the depressor (25). Insert the screw (26) into the holder (4) and fasten it.
7
．
Insert the saw blade (23) again as described in 9.3.
8
．
Ensure that the depressor (25) does not contact the saw blade (23).
The depressor (25) must always be adjusted according to the workpiece height. However, the
workpiece should not be clamped, but should rather be able to move freely.
The depressor (25) is used to lock the workpiece so that it cannot swing upwards, which would destroy
the saw blade (23).
8.2 Installing the blow-off device (fig. 8)
1
．
Ensure that the saw blade guard (5) folded down.
2
．
Screw the blow-off device (1) clockwise onto the holder(2) as described in fig. 8.
8.3 Changing the saw blade (fig. 1, 8-11)
IMPORTANT
To avoid injuries attributed to inadvertent startup: Before removing or replacing the saw blade, al- ways
press “0“ and remove the mains plug from the socket.
8.3.1 Removing the saw blade without pins (optional)
1.
To remove the saw blade (23) , lift the table insert (27) upwards.
2.
First, release the tension by flipping the tension lever (12) upwards. Continue reducing the tension by turning
clock- wise as required.
3.
Press the support (13) down lightly (see fig. 9).
4.
Then loosen the upper saw blade clamping lever (29), followed by the lower saw blade clamping lever (30) using
the Allen key (24)
8.3.2 Inserting the saw blade without pins (optional)
The teeth of the saw blade must always point downwards.
1.
First, secure the saw blade (23) in the lower saw blade mounting (31). To secure the saw blade (21), tighten the
lower saw blade clamping screw (30) using the Allen key (24).
2.
Press the support (13) down lightly. Fasten the other end of the saw blade (23) in the top saw blade holder (28)
(see fig. 9).
3.
Fix the saw blade (23) with the upper blade clamping screw (29) (see fig. 10).
4.
Tighten the saw blade (23) with the clamping lever (12), by pressing it down again. Check the tension of the saw
blade (23). If the tension is insufficient, it can be increased by turning the lever clockwise. First release the
clamping lever (12).
5.
Put the table insert (27) back.
