Thin material per manufacturer
recommendation.
Thin material per manufacturer
recommendation.
ATOMIZATION
IS TOO
COARSE
Viscosity of material too high.
Flow control knob setting too high
Decrease flow control setting
Air hose split or disconnected
Check air hose
Air inlet blocked
Clean or change air filter
Canister loose
Screw canister tightly in place
Quick refill lid loose
Screw quick refill lid tight in place
SPRAYER
PULSATES.
Air filter clogged
Clean or change air filter
Material in canister almost empty.
Refill canister.
Canister loose
Screw canister tightly in place
Quick refill lid loose
Screw quick refill lid tight in place
SPRAY
MATERIAL
DOES NOT
COVER
PROPERLY
Flow control knob setting too low.
Increase flow control setting
Clearance to target area too large
Reduce spray distance
Too few spray paths sprayed
over target area
Apply more spray paths sprayed
over target area
Viscosity of material too high.
TROUBLE!
WHAT’S WRONG?
WHAT TO DO…
- 22-
Summary of Contents for SGP17AC
