31
Repair or replace the tube with a new one, and
assemble the wheel again
It’s recommended to
Inflate the wheel to 2.0 bar / 30
psi.
! Be aware not to squeeze the tube between the two
rim parts when assembling.
! Notice the way of the valve before assembling the
rim. The valve fits in the cut-out of the rim, and
shall point away from the rim with the cut-out.
–
figure 5
! Never inflate to more than the tyre is marked.
Drive wheel
Lift the wheelchair
–
see introduction and figure 1
Loosen the bolt in the center of the wheel with a 19
mm spanner and pull off the wheel from the shaft.
Figure 6
Before splitting the rim, let the air out of the tube, by
pressing on the valve
–
figure 7
Screw the 3 bolt out of the rim with an 8 mm Allen
key
–
figure 8
Figure 5
Figure 6
Figure 7
Figure 8
Summary of Contents for 97050
Page 22: ...22...
